2. Remove the seal from the hub and measure the inside diameter of the hub where the seal was positioned. This measurement corresponds to the hub inside diameter on the chart.
3. To determine the proper model match your spindle and hub size to the Liqua-Lube part number on the chart below.
NOTE: One-fourth inch of wall thickness on the face of the hub is needed for the screws to secure the Liqua-Lube Cap.
1. Using a calipers, measure the diameter of the spindle at the point where the seal rides when the hub is on the spindle (A). This measurement corresponds to the spindle diameter on the chart below. The measurement will be .020” to .060” larger than the measurement on the chart. .
For 1.980" hub opening
2-Rugged, clear caps
2-Stainless Steel Spindle sleeves
2-Spring loaded seals
2-Adapters
2-Retaining Rings
Liqua-Lube® Lubricant
Easy Installation instructions
◦2-O-ring Cap Seals
◦2-Cap plugs with O-ring
◦8oz of Liqua-Lube Lubricant with easy pour spout
◦Easy Installation Instructions
NEW! Marine 3000lbs 6 bolt hub and drum
NEW! Non-Marine 3000lbs 6 bolt hub and drum
◦2-Rugged, clear caps
◦2-Stainless Steel Spindle sleeves
◦2-Spring loaded seals
◦6-Stainless Steel, Self Tapping Screws
◦1-Drill Bit
Liqua-Lube It! or Lose It!